Benutzer-Werkzeuge

Webseiten-Werkzeuge


wolkenthermometer_user_manual

Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

Link zu dieser Vergleichsansicht

Beide Seiten der vorigen Revision Vorhergehende Überarbeitung
Nächste Überarbeitung
Vorhergehende Überarbeitung
wolkenthermometer_user_manual [2015/04/17 18:03]
karl [Procedure]
wolkenthermometer_user_manual [2015/04/18 09:48]
karl
Zeile 20: Zeile 20:
     - line break: LF only     - line break: LF only
   - Check connection by pressing the reset button. \\ You shoud see a message like this <code>Project: WolkenThermometer V1.0 </code>   - Check connection by pressing the reset button. \\ You shoud see a message like this <code>Project: WolkenThermometer V1.0 </code>
-  - Then press and hold the reset button, until the counter is between and 5. This is the way how you enter the configuration mode. The terminal shows now something like this <code>Project: WolkenThermometer V1.0 +  - Then press and hold the reset button, until the counter is between and 8. This is the way how you enter the setup mode. 
-Built on Apr 17 2015 +
- +
-1234 +
-Welcome to the configuration of the WolkenThermometer +
-  For Help, please visit www.zeilhofer.co.at/wolke +
-  Info: Line terminations are with LF (\n). +
- +
-This WolkenSensor has been configured already. +
-  ID = 3 +
-Reconfigure it? (yes/no):</code>+
   - Follow the instructions of the configuration dialog. Here a full demo configuration: <code>Project: WolkenThermometer V1.0   - Follow the instructions of the configuration dialog. Here a full demo configuration: <code>Project: WolkenThermometer V1.0
 Built on Apr 17 2015 Built on Apr 17 2015
wolkenthermometer_user_manual.txt · Zuletzt geändert: 2015/04/18 09:48 von karl