Benutzer-Werkzeuge

Webseiten-Werkzeuge


wolkenthermometer_user_manual

Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

Link zu dieser Vergleichsansicht

Beide Seiten der vorigen Revision Vorhergehende Überarbeitung
Letzte Überarbeitung Beide Seiten der Revision
wolkenthermometer_user_manual [2015/04/17 18:03]
karl [Procedure]
wolkenthermometer_user_manual [2015/04/17 18:05]
karl
Zeile 20: Zeile 20:
     - line break: LF only     - line break: LF only
   - Check connection by pressing the reset button. \\ You shoud see a message like this <code>Project: WolkenThermometer V1.0 </code>   - Check connection by pressing the reset button. \\ You shoud see a message like this <code>Project: WolkenThermometer V1.0 </code>
-  - Then press and hold the reset button, until the counter is between 3 and 5. This is the way how you enter the configuration mode. The terminal shows now something like this <code>Project: WolkenThermometer V1.0 +  - Then press and hold the reset button, until the counter is between 3 and 5. This is the way how you enter the configuration mode. 
-Built on Apr 17 2015 +
- +
-1234 +
-Welcome to the configuration of the WolkenThermometer +
-  For Help, please visit www.zeilhofer.co.at/wolke +
-  Info: Line terminations are with LF (\n). +
- +
-This WolkenSensor has been configured already. +
-  ID = 3 +
-Reconfigure it? (yes/no):</code>+
   - Follow the instructions of the configuration dialog. Here a full demo configuration: <code>Project: WolkenThermometer V1.0   - Follow the instructions of the configuration dialog. Here a full demo configuration: <code>Project: WolkenThermometer V1.0
 Built on Apr 17 2015 Built on Apr 17 2015
wolkenthermometer_user_manual.txt · Zuletzt geändert: 2015/04/18 09:48 von karl