Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

--- wolkenthermometer_user_manual [2015/04/17 18:02]
karl [Procedure]
+++ wolkenthermometer_user_manual [2015/04/17 18:05]
karl
@@ Zeile 9: / Zeile 9: @@
 The user has to configure it with a serial adapter cable (UART, 3.3V or 5V).
-==== Procedure ====
+==== Configuration with UART adapter ====
   - Connect the serial dapter cable to the WolkenThermometers "Arduino Programming Port" P4 \\ Important: do not connect Pin 4 (reset), because then the push button is disabled \\ I'm using the FTDI UM230XB. You can also use another Arduino board (e.g. Arduino Nano), when you shorten the RST of that board to GND, and connect Rx with P4.3 and Tx of that board with P4.2.
   - Connect a battery
@@ Zeile 20: / Zeile 20: @@
     - line break: LF only
   - Check connection by pressing the reset button. \\ You shoud see a message like this <code>Project: WolkenThermometer V1.0 </code>
-  - Then press and hold the reset button, until the counter is between 3 and 5. This is the way how you enter the configuration mode. The terminal shows now something like this <code>Project: WolkenThermometer V1.0
+  - Then press and hold the reset button, until the counter is between 3 and 5. This is the way how you enter the configuration mode.
-Built on Apr 17 2015
-Welcome to the configuration of the WolkenThermometer
-  For Help, please visit www.zeilhofer.co.at/wolke
-  Info: Line terminations are with LF (\n).
-This WolkenSensor has been configured already.
-  ID = 3
-Reconfigure it? (yes/no):</code>
   - Follow the instructions of the configuration dialog. Here a full demo configuration: <code>Project: WolkenThermometer V1.0
 Built on Apr 17 2015

Verschiedenste Artikel von Karl Zeilhofer

Benutzer-Werkzeuge

Webseiten-Werkzeuge

Unterschiede

Seiten-Werkzeuge