Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

--- wolkenthermometer_user_manual [2015/04/17 18:02]
karl [Procedure]
+++ wolkenthermometer_user_manual [2015/04/17 18:03]
karl [Procedure]
@@ Zeile 9: / Zeile 9: @@
 The user has to configure it with a serial adapter cable (UART, 3.3V or 5V).
-==== Procedure ====
+==== Configuration with UART adapter ====
   - Connect the serial dapter cable to the WolkenThermometers "Arduino Programming Port" P4 \\ Important: do not connect Pin 4 (reset), because then the push button is disabled \\ I'm using the FTDI UM230XB. You can also use another Arduino board (e.g. Arduino Nano), when you shorten the RST of that board to GND, and connect Rx with P4.3 and Tx of that board with P4.2.
   - Connect a battery

Verschiedenste Artikel von Karl Zeilhofer