Hier werden die Unterschiede zwischen zwei Versionen angezeigt.
Beide Seiten der vorigen Revision Vorhergehende Überarbeitung Nächste Überarbeitung | Vorhergehende Überarbeitung Nächste Überarbeitung Beide Seiten der Revision | ||
wolkenthermometer_user_manual [2015/04/17 17:26] karl |
wolkenthermometer_user_manual [2015/04/17 18:03] karl [Procedure] |
||
---|---|---|---|
Zeile 9: | Zeile 9: | ||
The user has to configure it with a serial adapter cable (UART, 3.3V or 5V). | The user has to configure it with a serial adapter cable (UART, 3.3V or 5V). | ||
- | ==== Procedure | + | ==== Configuration with UART adapter |
- | - Connect the serial dapter cable to the WolkenThermometers " | + | - Connect the serial dapter cable to the WolkenThermometers " |
+ | - Connect a battery | ||
+ | - Open a serial terminal application on the computer \\ I use cutecom on linux. For Windows I recommend hterm | ||
+ | - Terminal Settings: | ||
+ | - Baudrate: 9600 baud/s | ||
+ | - 8 data bits | ||
+ | - no parity bit | ||
+ | - 1 stop bit | ||
+ | - line break: LF only | ||
+ | - Check connection by pressing the reset button. \\ You shoud see a message like this < | ||
+ | - Then press and hold the reset button, until the counter is between 3 and 5. This is the way how you enter the configuration mode. The terminal shows now something like this < | ||
+ | Built on Apr 17 2015 | ||
+ | |||
+ | 1234 | ||
+ | Welcome to the configuration of the WolkenThermometer | ||
+ | For Help, please visit www.zeilhofer.co.at/ | ||
+ | Info: Line terminations are with LF (\n). | ||
+ | |||
+ | This WolkenSensor has been configured already. | ||
+ | ID = 3 | ||
+ | Reconfigure it? (yes/ | ||
+ | - Follow the instructions of the configuration dialog. Here a full demo configuration: | ||
+ | Built on Apr 17 2015 | ||
+ | |||
+ | 1234 | ||
+ | Welcome to the configuration of the WolkenThermometer | ||
+ | For Help, please visit www.zeilhofer.co.at/ | ||
+ | Info: Line terminations are with LF (\n). | ||
+ | |||
+ | This WolkenSensor has been configured already. | ||
+ | ID = 3 | ||
+ | Reconfigure it? (yes/no): yes | ||
+ | Please Enter ID: 3 | ||
+ | Please Enter Secret-Key (10 characters): | ||
+ | Please Enter Public-Key (10 characters): | ||
+ | Do you want to set SSID and WiFi-Password now (yes/no)? | ||
+ | yes | ||
+ | Please Enter WiFi-SSID (max. 30 characters): | ||
+ | Please Enter WiFi password (0...30 characters): | ||
+ | The configuration is finished. Please go on with the smart phone app</ | ||
+ | - Unplug the UART-cable | ||
+ | - Restart the firmware by pressing the reset button shortly | ||
+ | - After about 20s the first measurement data should be sent to the server | ||
+ | - Check this with this url: \\ http:// | ||