Hier werden die Unterschiede zwischen zwei Versionen angezeigt.
Beide Seiten der vorigen Revision Vorhergehende Überarbeitung Nächste Überarbeitung | Vorhergehende Überarbeitung | ||
wolkenthermometer_user_manual [2015/04/17 18:02] karl [Procedure] |
wolkenthermometer_user_manual [2015/04/18 09:48] karl |
||
---|---|---|---|
Zeile 9: | Zeile 9: | ||
The user has to configure it with a serial adapter cable (UART, 3.3V or 5V). | The user has to configure it with a serial adapter cable (UART, 3.3V or 5V). | ||
- | ==== Procedure | + | ==== Configuration with UART adapter |
- Connect the serial dapter cable to the WolkenThermometers " | - Connect the serial dapter cable to the WolkenThermometers " | ||
- Connect a battery | - Connect a battery | ||
Zeile 20: | Zeile 20: | ||
- line break: LF only | - line break: LF only | ||
- Check connection by pressing the reset button. \\ You shoud see a message like this < | - Check connection by pressing the reset button. \\ You shoud see a message like this < | ||
- | - Then press and hold the reset button, until the counter is between | + | - Then press and hold the reset button, until the counter is between |
- | Built on Apr 17 2015 | + | |
- | + | ||
- | 1234 | + | |
- | Welcome to the configuration of the WolkenThermometer | + | |
- | For Help, please visit www.zeilhofer.co.at/ | + | |
- | Info: Line terminations are with LF (\n). | + | |
- | + | ||
- | This WolkenSensor has been configured already. | + | |
- | ID = 3 | + | |
- | Reconfigure it? (yes/ | + | |
- Follow the instructions of the configuration dialog. Here a full demo configuration: | - Follow the instructions of the configuration dialog. Here a full demo configuration: | ||
Built on Apr 17 2015 | Built on Apr 17 2015 |